How-To: Debug a protocol source

Perform steps 1 to 5 of How-To: Validate a protocol source, then:

  1. you may want to change the step granularity by using the related control
  2. press the next step button, the process will stop in the appropriate point, according to the selected step granularity:
    • the current instruction is highlighted
      the highlighted insttruction
    • the current rule element is selected
      the current rule
    • the content of the containers and the substitution map is shown
      the containers' status
  3. press the back step button if you wish to go back to the previous instruction
  4. if you wish to terminate the debug session:

Repeat steps 1 to 4 for each validation step.